收藏本站
PIC18F2450/4450
2006 Microchip Technology Inc.
Advance Information
DS39760A-page 153
15.0
ENHANCED UNIVERSAL
SYNCHRONOUS RECEIVER
TRANSMITTER (EUSART)
The Universal Synchronous Asynchronous Receiver
Transmitter (USART) module is one of the two serial
I/O modules. (USART is also known as a Serial
Communications Interface or SCI.) The USART can be
configured as a full-duplex asynchronous system that
can communicate with peripheral devices, such as
CRT terminals and personal computers. It can also be
configured as a half-duplex synchronous system that
can communicate with peripheral devices, such as A/D
or D/A integrated circuits, serial EEPROMs and so on.
The
Enhanced
Universal
Synchronous
Receiver
Transmitter (EUSART) module implements additional
features, including Automatic Baud Rate Detection
(ABD) and calibration, automatic wake-up on Sync
Break reception and 12-bit Break character transmit.
These features make it ideally suited for use in Local
Interconnect Network bus (LIN bus) systems.
The EUSART can be configured in the following
modes:
Asynchronous (full-duplex) with:
- Auto-wake-up on character reception
- Auto-baud calibration
- 12-bit Break character transmission
Synchronous – Master (half-duplex) with
selectable clock polarity
Synchronous – Slave (half-duplex) with selectable
clock polarity
The pins of the Enhanced USART are multiplexed with
PORTC. In order to configure RC6/TX/CK and RC7/RX/
DT as an EUSART:
bit SPEN (RCSTA<7>) must be set (= 1)
bit TRISC<7> must be set (= 1)
bit TRISC<6> must be cleared (= 0) for
Asynchronous and Synchronous Master modes
or set (= 1) for Synchronous Slave mode
The operation of the Enhanced USART module is
controlled through three registers:
Transmit Status and Control (TXSTA)
Receive Status and Control (RCSTA)
Baud Rate Control (BAUDCON)
These are detailed on the following pages in
Register 15-1,
Register 15-2
and
Register 15-3,
respectively.
Note:
The EUSART control will automatically
reconfigure the pin from input to output as
needed.
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
DSPIC30F3014T-20I/PT IC DSPIC MCU/DSP 24K 44TQFP
DSPIC30F3014T-20I/ML IC DSPIC MCU/DSP 24K 44QFN
PIC16LF819T-I/MLTSL IC PIC MCU FLASH 2KX14 28QFN
PIC16LF819T-I/SOTSL IC PIC MCU FLASH 2KX14 18SOIC
PIC18LF8410T-I/PT IC PIC MCU FLASH 8KX16 80TQFP
PIC18F2410T-I/ML IC PIC MCU FLASH 8KX16 28QFN
PIC18F2331T-E/SOG IC PIC MCU FLASH 4KX16 28SOIC
PIC18F4331T-I/ML IC MCU FLASH 4KX16 44QFN
相关代理商/技术参数
PIC16C55A-04/P 制造商:Microchip Technology Inc 功能描述:IC 8BIT CMOS MCU 16C55 DIP28
PIC16C55A-04/P 制造商:Microchip Technology Inc 功能描述:Microcontroller IC Number of I/Os:20
PIC16C55A-04/SO 功能描述:8位微控制器 -MCU .75KB 24 RAM 20 I/O 4MHz SOIC-28 RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
PIC16C55A-04/SO 制造商:Microchip Technology Inc 功能描述:8BIT CMOS MCU SMD 16C55 SOIC28
PIC16C55A-04/SP 功能描述:8位微控制器 -MCU .75KB 24 RAM 20 I/O 4MHz SPDIP-28 RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
PIC16C55A-04/SS 功能描述:8位微控制器 -MCU .75KB 24 RAM 20 I/O 4 MHz SSOP-28 RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
PIC16C55A-04E/P 功能描述:8位微控制器 -MCU .75KB 24 RAM 20 I/O RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
PIC16C55A-04E/SO 功能描述:8位微控制器 -MCU .75KB 24 RAM 20 I/O RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT